Irrigation dimensioning of reel machines with water distribution systems: gun and boom with emitters
DOI:
https://doi.org/10.35305/curiham.v26i0.152Palavras-chave:
reel machines, gun, boom with emitters, water distribution, irrigation dimensioningResumo
The reel machines irrigation technique has expanded in recent years thanks to the technological improvements that have been introduced. Several investigations have been carried out regarding the effectiveness of the irrigation of this equipment with “gun” type water distribution systems, but very few about the “boom with emitters”. This includes methodological or calculation procedures for dimensioning irrigation in an agricultural area. Therefore, the objective of this work is to establish a comprehensive methodology for the correct dimensioning of irrigation by reel machines with water distribution systems of the "gun" and "boom with emitters" type. Agronomic design is addressed as a fundamental part, and hydraulic design up to the necessary pressure in the hydrant. The relevant aspects in this procedure are that, formulations are included for the dimensioning of irrigation with water distribution systems of the “boom with emitters” type, and that correct values and criteria are used to support the methodology, because these come from authors and institutions of international prestige.
Downloads
Métricas
Referências
Allen, R. G.; Keller, J. and Martin, D. (2000). Center pivot system design. The irrigation association. VA, USA. 300 p. Recuperado de http://www.irrigation.org
González, P. (2003). Avances del riego en el cultivo de la papa en Cuba: Las máquinas de pivote central. Revista Ciencias Técnicas Agropecuarias, 12 (4): 39-43.
Hansen V. E., Israelson O.W. and Stringham G. E. (1980). Irrigation: Principles and Practices. Fourth Edition. New York, USA, Chichester: Wiley.
Jiménez E. R.; Montero L. and Zanette J. (2015). Evaluación de la calidad de riego de máquinas móviles (enrolladores). Revista Ingeniería Agrícola, 5(3): 29-34.
Keller J. and Bliesner R. D. (1990). Sprinkle and Tickle Irrigation. New York, NY, USA, Van Nostrand Reinhold.
National Resources Conservation Service (NRCS) (2005). Irrigation System Design (chapter 6), 210-vi-NEH 652, IG Amend. NJ1. United State Department of Agriculture (USDA). Recuperado de www.nrcs.usda.gov/Internet/FSE_DOCUMENTS/nrcs141p2_017641.pdf
Rolim J. and Teixeira J. L. (2016). The design and evaluation of travelling gun irrigation systems: Enrolador Software. Engenharia Agrícola, 36(5): 917-927. doi: http://dx.doi.org/10.1590/1809-4430-Eng.Agric.v36n5p917-927/2016.
Sánchez, J. A.; Fernández, Y.; Martínez , M.; Bonet, C.; Hernández, M. A.; Noy, A. (2015). Régimen de riego de explotación con la técnica por enrolladores, en el cultivo de la caña de azúcar (Saccharumofficinarum L.). Agrisost, 22(1): 9-23.
Santos L., de Juan J. A., Picornell M. R. and Tarjuelo J. M. (2010). El Riego y sus Tecnologías. Centro Regional de Estudios del Agua. Universidad de Castilla-La Mancha Campus universitario s/n 02071 Albacete. España. ISBN: 13:978-84-692-9979-1.
Saxton K. E., Rawls W. J., Romberger J.S. and Papendick R. I. (1986) Estimating Generalized Soil-water Characteristics from Texture. Soil Science Society of America Journal. 50(4): 1031-1036.
Soil Conservation Service. (1993). Irrigation Water Requirements (chapter 2). National
Engineering Handbook (part 623). United States Department of Agriculture. (210-vi-NEH, September 1993) 2–1.
Tarjuelo, J.M. (2005). El riego por aspersión y su tecnología. Madrid, Barcelona, México.Ed. Ediciones Mundi Prensa, 3ra edición, ISBN: 84-8476-225-4.
Uribe, H. C.; Lagos, L. O. and Holzaphel, E. (2001). Pivote Central. Comisión Nacional de Riego, Corporación de Fomento de la Producción. Chile. Recuperado de http://www.cnr.gob.cl.
Downloads
Publicado
Como Citar
Edição
Seção
Licença
![Creative Commons License](http://i.creativecommons.org/l/by-nc-sa/4.0/88x31.png)
Este trabalho está licenciado sob uma licença Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.